Issue №3, Vol. 16
Konstantinov V., Borisov V., Akinin D. The influence of a saw chain dynamics on cutting links wear // Resources and Technology. 2019. №3, Vol. 16. P. 24‒32.



DOI: 10.15393/j2.art.2019.4703

The influence of a saw chain dynamics on cutting links wear

Konstantinov
   Valery 		Moscow State Technical University named after N. E. Bauman (Mytishchi branch), konstantinov@mgul.ac.ru
Borisov
   Vyacheslav 		Moscow State Technical University named after N. E. Bauman (Mytishchi branch), vborisov@bmstu.ru
Akinin
   Dmitry 		Moscow State Technical University named after N. E. Bauman (Mytishchi branch), akinin@mgul.ac.ru
Key words:
the teeth of a saw chain; the cutting edge; chip thickness; resistance to cutting; cutting speed; wear of cutting links; work dynamics		 Summary: This study is aimed at determination of the normal contact pressure which acts on the cutting edge at different points of the contact area. The law of their distribution is described by the formulas of the theory of elasticity. To calculate normal pressures at a wear chamfer of a certain width in the cross sections perpendicular to the main cutting edge one of the solutions of the plane contact problem for the case of a rigid stamp (Flaman problem) can be used. The calculations analysis shows that the additional pressure caused by relative vibrations of the tool and rough workpiece increases indefinitely near the cutting edge and decreases smoothly when removed from it. Shear stresses near the cutting edge also increase indefinitely causing rapid wear and rounding of the cutting edge.

Displays: 892; Downloads: 443;